Rust Encapsulator Platinum is a high-performance, moisture cured coating that encapsulates and stops rust from spreading.
Three times Stronger than Original Rust Encapsulator
Metallic Silver Finish
Apply Directly Over Surface Rust
Heat Resistance to 350 Degrees F
Apply with Brush or Spray
Rust Encapsulator Platinum can be used as a top coat or can be top coated with almost any paint. It can be applied over bare metal or surface rusted areas. Brush or spray applied with conventional spray equipment. Rust Encapsulator Platinum is ideal for any type of rusted metal surface and can withstand temperatures up to 350 degrees F.
More Information
Product Name
Eastwood Rust Encapsulator Platinum Quart
Warranty Term
None
Is ESP
No
Is Canceled
No
90 Day Returns
Yes
ATF Recommended products - Enabled
No
specifications_ax
Single component aluminum pigmented coating
67% solids by weight
Proprietary additive increases product adhesion to rusted steel substrates- unmatched by competitive coatings
1 coat assures maximum protection
Brush, roller or spray applied
Paint Gun: HVLP gravity or siphon with a 1.4 minimum needle/nozzle
Re-coat able after 4 hrs.- if top coating after 48 hrs., scuff surface with 320 grit paper
2 hrs., tack free
Easy to apply
Topcoat able with virtually any high-quality coating
Maximum service temp of 350° Fahrenheit
Recommended Substrates and Prep
Apply product as a primer/Encapsulator over clean or corroded (rusted) steel or cast iron
Prep surface by mechanically cleaning loose flaking rust with a stiff brush or wire brush/wheel
Remove any grease, oils or other surface contaminants with a solvent such as PRE or Acetone
Apply by brush, roller or spray
warranty_ax
This product has a 2 Year Shelf Life
Storage Case Included
No
Do Not Use - Instructions - Depreciated
1. Clean loose rust and scale with stiff wire brush before application.
2. Clean surface to be painted with PRE Painting Prep # 10041Z or lacquer thinner. Allow to dry.
3. Application Temperature/Time to Recoat: Apply when metal surface temperature is between 40F and 80F. Top coat after 4 hours up to 48 hours. After 48 hours surface must be scuff sanded with Scotchbrite pad or 320 grit paper for maximum adhesion.
4. Brush Application: Apply one medium wet coat with bristle brush to all rusted areas. Assure hard to reach areas are coated.
5. Spray Application: Product can be thinned up to 20% with Xylene. Clean spray equipment immediately with acetone or lacquer thinner.
6. Product Storage: If product is to be stored in this container. Wipe recessed area on can area to remove product before closing lid. Failure to clean area will result in lid bonding to can and destroying product.
Do Not Use - Safety Info - Depreciated
Be sure to always wear all personal safety equipment when working with this or any coatings. <br><br> <i><b><a href="https://www.eastwood.com/shop-equipment/safety-equipment.html">Click here to see safety products</a></b></i>
