Pressure Blaster Pull Up Gasket
In stock
SKU
22005
Pressure Blaster Pull Up Gasket is rated
out of
5 by
4.
Provides an airtight seal for pull-up plunger on 22008, 22011, 50096 blasters
Loading...
This durable rubber gasket provides an air-tight seal for the pull-up plunger on our Model 100 (22008) and 110 (22011) (50096) pressure blasters.
| Product Name | Pressure Blaster Pull Up Gasket |
|---|---|
| Warranty Term | None |
| Is ESP | No |
| Is Canceled | No |
| 90 Day Returns | Yes |
| ATF Recommended products - Enabled | No |
| specifications_ax | Outside Diameter: 4" Inside Diameter: 3" |
| Storage Case Included | No |
| Do Not Use - Application - Depreciated | This durable rubber gasket provides an air tight seal for the Pull-Up plunger on our Model 100 (22008) and 110 (22011) (50096) pressure blasters. To remove old gasket carefully peel away from the locating channel (EDGES ARE SHARP!!!) and push in the replacement. |
| Do Not Use - Instructions - Depreciated | 1 |
| Do Not Use - Safety Info - Depreciated | Exercise care when replacing gasket. The edges of the channel the gasket fits in are sharp.<BR>WARNING: Blasting emits abrasive under pressure. Adequate respiratory, eye, & body protection must be worn during use. Inhalation of silica particles can cause cancer & other deadly diseases. Wear NIOSH- approved respiratory protection during operation |
Related Products
-
Bullseye Pick Blunt TipSale $14.98 Reg. $16.99 Save $2.01
