Motor Guard Stud Welder Dent Pulling System
In stock
SKU
31041
Motor Guard Stud Welder Dent Pulling System is rated
out of
5 by
15.
Spot-weld the pins, pull pins to pull-out dent, snip and grind them down
Loading...
Stud Welder Dent-Pulling System makes a hole-free dent repair, so it won’t weaken the panel, and needs less filler.
- Stud welder spot-welds pins onto the dented metal surface
- Pull the pins to pull-out the dent
- Snip the pins, then grind the rest down
3-step repair works without drilling holes, so it won't compromise the strength of the panel. The result is a professional-looking dent repair that requires minimal filler.
| Product Name | Motor Guard Stud Welder Dent Pulling System |
|---|---|
| Warranty Term | Manufacturer |
| Is ESP | No |
| Is Canceled | No |
| 90 Day Returns | Yes |
| ATF Recommended products - Enabled | No |
| FAQ's | (Q) Do I need a 220-volt system to operate this? (A) No, standard 110v will work. (Q) Do I need a welding mask when using this? (A) It’s not necessary, but don’t look directly into the momentary flash. (Q) How do I get the pins off after they’ve been welded onto the surface? (A) After you’ve made your pulls, simply snip or grind the pins off. |
| Size/Content | The Stud Welder Kit includes: the Stud Welder Gun, Large Slide Hammer Puller with 2 lb sliding weight, a package of 100 2mm Draw Pins, and an owner's manual. |
| Storage Case Included | No |
| Do Not Use - Application - Depreciated | The Stud Welder Dent Pulling System makes pulling dents from one side possible without drilling holes! The Stud Welder Kit includes: the Stud Welder Gun, Large Slide Hammer Puller with 2 lb sliding weight, and a package of 100 2mm Draw Pins. Easy to use, simply grind away paint in damaged area, load draw pin into gun, push spring loaded stud weld gun against surface until outer contact ring touches surface, and trigger gun for less than a second to anchor the pin. |
| Accessories | The Shrinking Electrode Tip (31041 A) turns your stud Welder into an effective tool for shrinking metal. Simply install the shrinking electrode, push the tip fully against the raised spot and trigger the gun for 1/2 second 2-3 times. If dent does not shrink tap lightly with a body hammer. |
| Do Not Use - Safety Info - Depreciated | Stray sparks normally occur during use of this tool. Therefore, keep all flammables out of the immediate area. |
Related Products
-
Eastwood Sheet Metal Gauge$20.99 -
Key To Metal Bumping Book$20.99
